...Energy All interface cables used with this equipment must be shielded in order to maintain compliance with radio frequency energy emission regulations and ensure a suitably high level of immunity to electromagnetic disturbances . European EMC dir...

...computer through a USB cable . Both selected and non - selected computers maintain a constant connection with the unit’s keyboard - mouse emulation controllers , allowing for ultra - fast switching and restricting discovery of newly connected perip...

...installed and used according to the instructions in this manual , together with the specified cables and the maximum cable length < 3m , the Units : ACS2009A - R2 - MM , ACS2009A - R2 - SM , ACS2209A - R2 - MM , ACS2209A - R2 - SM ACS4001A - R2 -...

...unplug the Video - Cable to the Remote Monitor ( Dualhead devices : BOTH Monitors ! ) • Open the Local Unit like described above • Unplug Jumper JP1 and plug it to Position JP3 ( Dualhead devices : jumper setting on BOTH PCB’s ! ) • Switch on t...

...that is , in strict accordance with the manufacturer’s instructions , may cause interference to radio communication . It has been tested and found to comply with the limits for a Class A computing device in accordance with the specifications in Su...

...LMC3001A MGT Cascade Cable ( 3 ft . ) � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � � Network Management Software for � � � � � � � � � � � � � � � � � � � ...

...MULTIMODE FIBER OPTIC CABLE AT DISTANCES OF UP TO 30 KM ( DEPENDING ON THE SFP USED , FIBER TYPE , AND FIBER BANDWIDTH * ) §   SUPPORTS TRANSPARENT USB EXTENSION VIA TWO USB 2.0 PORTS PLUS TWO USB 1.1 PORTS FOR USB HUBS OR USB HIDS SUCH AS TOUCHSC...

...BOX Supports maximim cable runs of up to 1000 feet ( 304.8 m ) . Can be triggered by any other sensor connected to the AlertWerks Hub . Specifications Overview Communications Cable — RJ - 45 jack to sensor using UTP CAT5 cable The combined siren ...

...one end of an HDMI cable to the HDMI port on the source device ( e.g . computer , server or other IT device ) . Then connect the other end to the HDMI IN port located on the TX unit . 3 . Connect the HDMI display to the HDMI OUT port on the TX ...

...What’s in the box Video cable to connect a transmitter to the source PC and optionally to connect additional transmitter modules in cascade . * The Wizard AVU5001A and AVU5011A are packaged as a transmitter and receiver pair ( AVU5010A ) as well as ...